generator waste heat recovery systems

Purchased equipment: generator waste heat recovery systems
Location: WUXI China
Telephone: +86 13861509127
Contact us for more details about our boilers, solutions and services.

High quality aluminum silicate fiber is used with fire clay insulation, to control the boiler body temperature below 45℃ and reduce heat lost.Sufficient steam storage room and heating area to generate high quality steam and high thermal power.Condenser is added to recycle the waste heat of the exhausted smoke to increase feeding water’s temperature and reduce flue gas emission temperature and increase the thermal efficiency over 98% and save operating cost.

Environmental protection

Big combustion chamber equipped with Low emission combustion burner effectively reduce the NOx to 30mg/m3. Smoke duct and smoke outlet use internal insulation to reduce operating noise.

Combustion chamber uses full membrane water cooling wall structure and pressurized combustion without smoke mixture.

Energy conservation

Good quality alumina silicate fiber and fire clay insulation material are used and the boiler body temperature is controlled below 45℃ and greatly heat loss is reduced. Combustion chamber is designed with narrow distance tube membrane water cooling wall which has good air proof to reduce heat lost and increase boiler thermal efficiency. Internal inspection holes uses high-alumina refractory and manhole cover seal devices, solving superheat problem in this part caused by using refractory bricks.

CNC manufacturing technology

The key processing technologies such as steel plate blanking, circling, drum and tube plate drilling adopt advanced CNC machining to reduce the assembly stress and prolong the service life of the boiler.

Steel tube cutting, thread tube pressing and convection tube processing all adopt advanced CNC technology.

Automatic production line.

Leave a Comment


Energy Tips – Process Heati

heat gas recovery systems to capture and use some of the energy in the flue gas. For natural gas-based systems, the amount of heat contained in the flue gases as a percentage of the heat input in a heating system can be estimated by using Figure 1.

Thermoelectric generators: Linking material properties an

The abundance of waste-heat sources and increasing energy efficiency goals make waste-heat recovery with thermoelectric power generation a promising technology. The realization of commercial thermoelectric generators hinges on solving the intimately coupled challenges with materials development and systems engineering.

Waste Heat Recovery | Cummins Afri

Cummins pioneered waste heat recovery systems in Nigeria. Trigeneration. Tri-generation, also known as Combined Cooling Heat and Power (CCHP), utilises waste heat from the engine to generate steam or additional electricity, as well as integrating absorption chillers into the circuit.

Home - Clearpower Syste

The ClearPower Systems Inc. 50 kw heat to power generator can be used in conjunction with other renewable energy alternatives such as solar, municipal solid waste, and biomass to produce electrical power.

Waste Heat Recovery | Bowman Power - Waste to Energ

Waste Heat Recovery for Power Generation Markets. Our ETC system is used by engine and generator set (genset) OEMs, power rental providers and independent power producers (IPPs), to increase competitive advantage and add value to genset end-users.

An Engine System Approach to Exhaust Waste Heat Recove

An Engine System Approach to Exhaust Waste Heat Recovery Principal Investigator: Richard W. Kruiswyk Caterpillar Inc. Note: This presentation does not contain any proprietary or confidential information. Generator Power W 0 10 20 30 40 50 60 70 80 90 100 Elecronics O/ P power (W)

Heat recovery steam generator - Wikiped

A heat recovery steam generator (HRSG) is an energy recovery heat exchanger that recovers heat from a hot gas stream. It produces steam that can be used in a process (cogeneration) or used to drive a steam turbine (combined cycle).

Waste Heat Recovery Power Generator Ahmet Durm

TOSHIBA MITSUBISHI-ELECTRIC INDUSTRIAL SYSTEMS CORPORATION < Confidential to TMEIC Corporation> Houston, Texas, USA Waste Heat Recovery Power Generator. Proprietary to TMEIC Corporation Page 2 • Increasing energy prices and CO 2 emission controls • 20-50% of industrial energy Huge potential in waste heat recovery although not known

Waste heat recovery unit - Wikiped

A waste heat recovery unit (WHRU) is an energy recovery heat exchanger that transfers heat from process outputs at high temperature to another part of the process for some purpose, usually increased efficiency.

Waste Heat Recovery Generator | Kinectic Traction System

The KTSi Waste Heat Generator is based on the Organic Rankine Cycle (ORC) technology. The ORC is a thermodynamic cycle that uses an organic fluid to convert low temperature heat into mechanical work. That mechanical work can then be converted into usable electricity.

Heat Recovery Steam Generators (HRSG) | GE Pow

The heat recovery steam generator (HRSG) provides the thermodynamic link between the gas turbines and steam turbines in a combined-cycle power plant. Each HRSG solution is custom-engineered to meet your desired operating flexibility and performance requirements.